x
x

H&S 622

Double tap to zoom

H&S 622

 

Features

  • H&S models 410, 412, 415, 612, 614, and 617 have L-shaped front spindles with structural bracing to withstand high stresses from shock loads.
  • The H&S heavy running gears – models 415 through 622 – utilize thrust bearings to assure dependable, smooth turning and straight trailing.
  • The tele-pole is made of structural tubing and the mounting plates have wide spacing between them to reduce sway and increase the strength of the pole.
  • King Pin, Hitch Pin, Spindles, Tie Rod Ends and Tie Rod Steering Pivot Point are all wear protected by replaceable oil impregnated steel bushings and are greaseable as well.
  • Full Contact Turn Stops distributes the pressure exerted in tight dragging turns along the bolster face – this reduces the possibility of bunk damage or collapse.
  • Running gears from 12 ton on up have 4-bolt brake flanges as standard equipment so that optional hydraulic surge brakes may be installed.
  • The tie rod is positioned behind the bolster on all models and is a one-piece design that reduces the number of wear point that could change the toe-in and tracking.
  • The spring assist is stan­dard on all models and is adjustable from a light assist to full support.
  • Front and rear stake pockets wear pockets are standard on ALL MODELS!

Specifications

622
CAPACITY 22 TON
WEIGHT W/TIRES 3580# w/21.5L
TREAD WIDTH 87″
SPINDLES 3″
HUBS 8 BOLT
BOLSTER 4″ x 8″
C-REACH ⅜″ WELDMENT
WHEEL BASE 119″ TO 179″ IN 10″ INCREMENTS
STANDARD WHEEL 16.1 x 18 or 22.5 x 13.5
WHEEL OPTIONS N/A
BRAKES OPT. HYD. SURGE
BACK HITCH N/A
TELESCOPING POLE FIXED AT 89″

Let us help you get moving

Fields with asterisks* are required. Please email our helpful staff with any questions or comments using the contact form.